Tecaform ® SD Static Dissipative Acetal
Datasheet
DESCRIPTION
Tecaform ® SD (formerly known as
Hydel ® ASD) is an acetal base material
that has been filled with an inherently dissipative polymer
(IDP) additive. IDP's have no carbon or graphite content and
do not slough conductive particles. This material has consistent
electrical properties, good wear resistance, broad chemical
resistance, and machines very easily.
Tecaform ® SD is
natural (tan) in color
and is available in sheet, rod, tubular bar and profile forms.
|
PROPERTIES of TECAFORM ®
SD Acetal |
| ASTM or UL test |
Property |
Tecaform ®
SD |
| PHYSICAL
|
| D792 |
Density (lb/in³)
(g/cm³) |
0.048
1.33 |
| D570 |
Water Absorption, 24 hrs (%) |
2.0 |
| MECHANICAL
|
| D638 |
Tensile Strength @ Break (psi) |
6,400 |
| D638 |
Tensile Modulus (psi) |
220,000 |
| D638 |
Tensile Elongation @ Break (%) |
15 |
| D790 |
Flexural Strength (psi) |
- |
| D790 |
Flexural Modulus (psi) |
215,000 |
| D790 |
Compressive Strength (psi) |
- |
| D256 |
IZOD Impact Notched (ft-lb/in) |
1.2 |
| D785 |
Hardness, Rockwell |
110 R |
| THERMAL
|
| D696 |
Coefficient of Linear Thermal Expansion
(x 10 -5 in./in./°F) |
9 |
| C177 |
Thermal Conductivity
(BTU-in/ft²-hr-°F)
(x 10 -4 cal/cm-sec-°C) |
-
- |
| D648 |
Heat Deflection Temp (°F / °C)
at 264 psi |
215 / 102 |
| - |
Max Operating Temp (°F / °C) |
180 / 82 |
| UL94 |
Flammability Rating |
- |
| ELECTRICAL
|
| D149 |
Dielectric Strength (V/mil) short time,
1/8" thick |
- |
| D150 |
Dielectric Constant at 1 KHz |
- |
| D257 |
Surface Resistivity (ohms/sq) |
10 10
- 10 11 |
| D257 |
Volume Resistivity (ohm-cm) at 50% RH |
10 10
- 10 11 |
NOTE: The information contained herein are typical values
intended for reference and comparison purposes only. They should
NOT be used as a basis for design specifications or quality
control. Contact us for manufacturers' complete material property
datasheets.
All values at 73°F (23°C) unless otherwise noted.
TECAFORM is a registered trademark
of Ensinger-Hyde
